Rex Plugs
04-03-2004, 11:00 AM
#1
Rex Plugs
Anyone have any experience with Rex glo plugs? I have never used em before, but my LHS had em so I tried.
I am attempting to break in an STS D5. Am using 15% Wild Cat fuel, have an .3 shim, RD Logics Turbo pipe , and the Rex 7/G05Tf plug. All the above as recommended in the instructions. Also, I have changed plugs once already. My problem is that I simply can not get it to maintain a decent idle. It will run fine for a minute or so, but then the idle goes up and up and it screams. Or, sometimes it simply wont stay running. If I keep the ignitor on it, it stays on, but after a couple seconds after I remove the ignitor, it stalls. Any suggestions, hints, tips, etc are appreciated
I am attempting to break in an STS D5. Am using 15% Wild Cat fuel, have an .3 shim, RD Logics Turbo pipe , and the Rex 7/G05Tf plug. All the above as recommended in the instructions. Also, I have changed plugs once already. My problem is that I simply can not get it to maintain a decent idle. It will run fine for a minute or so, but then the idle goes up and up and it screams. Or, sometimes it simply wont stay running. If I keep the ignitor on it, it stays on, but after a couple seconds after I remove the ignitor, it stalls. Any suggestions, hints, tips, etc are appreciated
04-03-2004, 11:52 AM
#2
Tech Addict
Sounds like you're too lean on the bottom.
Rex plugs are good plugs. They're the same as Nova plugs, but cheaper and easier to find. I run them when I can't find Novas.
Rex plugs are good plugs. They're the same as Nova plugs, but cheaper and easier to find. I run them when I can't find Novas.
04-03-2004, 12:28 PM
#3
Originally posted by tekrsq
Sounds like you're too lean on the bottom.
Rex plugs are good plugs. They're the same as Nova plugs, but cheaper and easier to find. I run them when I can't find Novas.
Sounds like you're too lean on the bottom.
Rex plugs are good plugs. They're the same as Nova plugs, but cheaper and easier to find. I run them when I can't find Novas.
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
