STS engines
#1651
Hi l ran my sts D3 on sunday at a club meeting it was nice and fast finsh 5th in the A main
can you still buy STS D3 if you can were??
Thanks
Ross
can you still buy STS D3 if you can were??
Thanks
Ross
#1653
D3R is much better in standard shape, D3 needs a lot of modifying to perform as the D3R, so if you can find a D3R, buy it fast
#1654
What are the needle settings for the regular D5.
Iread somewhere else that they were
4hsn
4lsn
middle flush
Is that right?
Iread somewhere else that they were
4hsn
4lsn
middle flush
Is that right?
#1655
Tech Adept
thanks for the bearing messurments....Im sorry i didnt say which engine.....
sts. .12 d5r
cheers.
sts. .12 d5r
cheers.
#1656
Tech Master
I think this was also posted earlier..
hsn 3.5
lsn 4.5
Midrange flush
will still need tune for local area (should be closer then 4/4/flush though)
hsn 3.5
lsn 4.5
Midrange flush
will still need tune for local area (should be closer then 4/4/flush though)
#1657
My motor is acting weird. It acts like its super rich but it isn't. I'm thinking my midneedle is 1 turn to rich. But I don't know. Maybe my plug is to hot. But I don't know anybody got any suggestions. I also am using Nightmares needle settings. The car barley move, the clutch is perfect but its that rich thing that I can't get right. Compression is also very tight.
#1658
Try going back to the stock settings. If your compression is good it will run good enough for you to dial your power back in.
#1659
Tried that but I probally need to lean it a good 2 turns before it makes any power. How hot can these motors run. Because if I want this thing to run itll have to run at about 280-300.
#1660
Does the piston still "pinch"? When you take out the glow plug does the piston still bind when it gets to the top? If it does the motor is not broken in yet and you still will have to run it rich until the piston stops binding. That extra friction from the piston binding will really jack up engine temps even if the motor is spitting rich. What nitro content are you running? Is your air filter clean? How is your body trimmed?
#1661
That was exactly the same problem we had with the STS engine here. After some polishing on the crank (and I use an old Novamax crankcase which I think has better tolerance than the STS) and use a 6mm pipe (as per Dino's suggestion), the problem was gone.
Rgds
Rgds
#1662
Well my motor was used, I took off my head and tried pulling the glow head part off but the whole sleeve came with it. Now im thinking that shouldn't happen. But of course I'm not sure. The engine has fine pinch. I also had a good air filter and I was running without a body in my r40. When there is no glow plug it has next to no pinch only a small bit of resistance. I like to run all my motors a small bit rich on the top end but this rich is rediculous.
#1663
I am also running 25 percent nitro with a hot turbo plug. I'm thinking of switching to a meduim or cold plug when I get back up to the lhs.
#1664
You may want to add a shim or two to the head or drop down to 20% nitro. Going to a colder plug may help too. Oh yea does your car roll well? Is anything draging?
#1665
I was surprised on how the car rolled it was very free for a belt car. Very close to my ntc3. Ill try to add a shim and drop to a colder plug.