keavze

hi,
just wana check are there any ways to replace the O rings on the LSN n HSN needles without tearing/fraying of the O rings?

i've just replaced mine and it's TIGHT. after i fully closed it and backed out to the desired settings, the O rings deformed and frayed...

any suggestions?

kcrunchone

iTrader: (1)

Lubrication is my method. Ky-effect LOL...

keavze

ya, tried that (not KY though... ) but still same...

jameslow

iTrader: (1)

Maybe u can check the internal surface of the needle screws holes! Check if there is scratches that casue tearing to the o ring!