BuKu Speed Tune Clutch & RC Performance Products
#1697
What's the weight difference between the brass and the alloy flywheel?
#1698
#1699
Will the 4 shoe clutch be released soon?
My composite shoes are finally worn and need replacement after many gallons of use. Just want to see if I should wait for 4 shoe to come out before ordering replacement for 3 shoe.
My composite shoes are finally worn and need replacement after many gallons of use. Just want to see if I should wait for 4 shoe to come out before ordering replacement for 3 shoe.
#1700
Tech Adept
could someone clarify the procedure for removing the grease from the clutch bell bearing, just ordered one of these and don't want to ruin the shoes right away.
#1701
Tech Adept
iTrader: (4)
I would recommend TKO's RT (radial thrust) bearings and the Speed-X oil. The bearings may be expensive but with maintenance they will last much longer than the cheaper ones.
Cheers
Brian
#1703
Tech Adept
So I used to run a Truggy on mostly high bite astroturf with the BuKu clutch.
Going to drive Buggy this year, any recomandations ? Can i still run the same shoes? Should i go havier/lighter? Using medium i thought..
Going to drive Buggy this year, any recomandations ? Can i still run the same shoes? Should i go havier/lighter? Using medium i thought..
#1707
Tech Adept
can anyone who is using this on a tlr help out, having an issue with my shims, how many should be between the engine and flywheel, nut and inner bearing etc. everytime I tighten my screw it locks up the flywheel- using the lutz rc vented losi bell
Last edited by rjkotzur; 03-23-2016 at 01:21 PM. Reason: add
#1708
Tech Initiate
Use the two brass shims behind the collet to bring the flywheel clear of the crankcase
#1709
have you guys ever used a good condition used bell with a new buku clutch? i'd like to go this route as i dont have 25 bones to shell atm. Would it really wear a lot faster or slip?