Frank L

iTrader: (148)

Heres what 1/2 throttle got me with using my thumb and a glove triple layered over itself on the damm fly wheel. Man theres gotta be a better way to stop these engines. Ill have to get the mad scientist on it.

trickedout

iTrader: (31)

Well im not calling anyone Stupid but, I would NEVER ever touch that flywheel unless the engine was at IDLE...thats just not too smart..LOL..

rider313

iTrader: (94)

I must have a keeper then. I just gave her one of the bands and said get these. and low and behold she got me not one but two packs of them, not i have throttle return bands like no tomorrow.

alexrckid

stop the engine..?? i almost always pinch the line.....this way i purge the fuel from the crankcase.......keeps that nasty HYDROSCOPIC fuel from hanging out around the bearings...........

pitpop

I use a sledge hammer, that way nobody gets hurt

aussies1129

iTrader: (74)

just carry one of these around very handy
http://www.rc-mushroom.com/product_i...ducts_id=14223

deadmancourt

iTrader: (11)

thats hilarious...hey bud, are you and cody gonna run the Airtronics race at Rev this saturday?...its gonna be a fun race...hopefully i will see you guys there

mgtmadness2007

iTrader: (4)

I use a 1/2 stick of Dynamite,(just push that 4th channel switch, I have programmed on my M11, and KABOOOM!!!) it works pretty darn well!!

aussies1129

iTrader: (74)

a guy at our track use to just stomp on the cars you should see the drivers crack up at that one

Frank L

iTrader: (148)

I know I have way too much education to stomp around in the mud but I still love doing it. Thanks for noticing.

j_blaze14

iTrader: (34)

shut off power, tip car so it points up, thumb on flywheel. works every time. on a run away, which usually end up upside down after hitting pipe or wall, just step on the chassis then wiggle your foot into the flywheel hole to cut it.

rangerjkb

iTrader: (45)

I use a pipe plug tool, I believe its a Dubro part, that cost about $1 or so...place in exhaust exit and it shuts off engine with no issues.

mk74

isnt there a fail-safe cable device for the receiver to prevent all this runaways?

rc racer 103

iTrader: (45)

[IMG][/IMG]
I came up with this so BOO BOO could shut his nitro engine down safely ,it has a 34"teather and a belt clip ,,they work great if anyone wants one pm me !!

cary

iTrader: (67)

nice job those like good!