Car goes wild
#1
Car goes wild
Ok i just got a futaba magnum junior 75.890mhz am
Whenever i start my nitro my whole servo/stearing&throle goes wild and cant be control.
But it is ok when i didn't start my motor.
I had change the Batteries to a new one but is still the same
FREAKING ME OUT
Is receiver DEAD ?
or is there any other solution without spending lots of money to fix it ?
BTW i live in malaysia
75am mhz looks ok rite ?
Please reply fast
I'm dying in here !
Whenever i start my nitro my whole servo/stearing&throle goes wild and cant be control.
But it is ok when i didn't start my motor.
I had change the Batteries to a new one but is still the same
FREAKING ME OUT
Is receiver DEAD ?
or is there any other solution without spending lots of money to fix it ?
BTW i live in malaysia
75am mhz looks ok rite ?
Please reply fast
I'm dying in here !
#2
make shure u have no lose screws on metal or graphite this will cause huge amounts of interferance
#4
well some ferquencys have problems with engine noise i am not shure of wich ones thay are , also did u check that no brake springs or throttel return springs are flaoting around
#7
look at the throttel servo then look at your brake and throttel linkages do they have spings of some sort ?
#8
Hey i look at my brake
is something like a peice of papper
there's one hole on to that ...i guess it must link to a throttle (THE ONE WITH LONG SHAFT)
correct ?
but mine is diffrent....
i guess the brake is loose..
i mean the hole are not connected
it suppose to connect rite ?
is something like a peice of papper
there's one hole on to that ...i guess it must link to a throttle (THE ONE WITH LONG SHAFT)
correct ?
but mine is diffrent....
i guess the brake is loose..
i mean the hole are not connected
it suppose to connect rite ?
#9
yes the brake has to conect to the servo horn some how and in your case a rod is used with a stoper on the end put a littel pice of fule tube between the stoper and the other piece of metal
#11
y is that
#12
is this a brand new car or have u ran it before
#14
the vibration of the engine makes lose thing jiggel and if it is metal on metal and or graphite it causes interfeance and makes the servos go like that
i dont see how u have to pull the tranmision out to play with your brake linkage
i dont see how u have to pull the tranmision out to play with your brake linkage
#15
i should say carbon fiber (same type of shit)