Team Magic G4
#2296
Originally Posted by Motorman2
The perimeter kits were done specifically for us. We asked them to do it. They were fairly popular but the factory told us they would be no longer because we didn't buy a gazillion to hang in the warehouse. They said it was not a good enough seller, however they never marketed it to the other distributors around the world. If they had it might have been a better seller.
Looks like that was some hit!! The individual part numbers for the pieces are coming but as in your case very slowly. Hoping they will be available next week so others won't be in same position.
#2297
Tech Master
iTrader: (10)
Originally Posted by otraver
Hi all
Recently I purchased the K14124 G4 Speed Shot Front Bulkhead System.
I used it in the last race of the 2006 spanish championship.
During the celebration of one clas heat I received a lateral hit that pushed me against the protection wall.
And the result has been the following ...
I was finish the heat but with a very unstable car. I believe that the alloy piece is too fragile and it bends with facility. I have been unbind it but I think that the material lost its rigidity.
In addition I donīt find as spare part and will be necessary to buy again the complete kit.
Best regards.
Recently I purchased the K14124 G4 Speed Shot Front Bulkhead System.
I used it in the last race of the 2006 spanish championship.
During the celebration of one clas heat I received a lateral hit that pushed me against the protection wall.
And the result has been the following ...
I was finish the heat but with a very unstable car. I believe that the alloy piece is too fragile and it bends with facility. I have been unbind it but I think that the material lost its rigidity.
In addition I donīt find as spare part and will be necessary to buy again the complete kit.
Best regards.
I am crash test master, i know what a crash can do.
#2298
My G4S's driving Movie in Korea Circuit
My G4S's driving Movie in Korea Circuit
http://flvs.daum.net/flvPlayer.swf?vid=3bXkcp1mEZ8$
how about you think?
http://flvs.daum.net/flvPlayer.swf?vid=3bXkcp1mEZ8$
how about you think?
Last edited by gansei; 10-06-2006 at 11:31 AM.
#2299
Originally Posted by gansei
http://flvs.daum.net/flvPlayer.swf?vid=3bXkcp1mEZ8$
how about you think?
thanks,
Gary
Duh... went back and read your title. Your G4S in Korea. Looks like you are an excellent driver. What engine in the car?
#2300
re:
Originally Posted by royfan33
Awesome!!! Any specifics? Car, engine, location?
thanks,
Gary
Duh... went back and read your title. Your G4S in Korea. Looks like you are an excellent driver. What engine in the car?
thanks,
Gary
Duh... went back and read your title. Your G4S in Korea. Looks like you are an excellent driver. What engine in the car?
my engine is GR tuned OS 12TZ 3port. and pipe is 5mm GPX-4(hyper).
GR is korea engine tunning company..
(http://www.grracing.co.kr)
http://pds11.cafe.daum.net/download....d&dncnt=N&.JPG
#2301
That is a bad crash and yes, it seems that part of the upper deck support is not strong. If you had the plastic top support, either the hub or upper/lower arm would have broke, which would have been good because those are easier and cheaper to replace.
I'll stick with the plastic for now.
I'll stick with the plastic for now.
#2302
Say it isn't so!!!
I just got off of the phone with my LHS and was told my parts may or may not be coming from Team Phenix due to Team Magic switching to Trinity for distribution. I'm not a happy camper. I like the personal touch from Motorman, and 25 years in R/C tells me that when certain large companies get their hands on distribution of rc products, prices go up and supply goes down. I would not have purchased a G4S had Trinity been the distributor 2 months ago.
#2303
rollbar replacement
G4S's rollbar is too low and can't protect engine in the crash..
so i changed G4S rollbar by V-ONE RRR rollbar (kawahara option part)
so i changed G4S rollbar by V-ONE RRR rollbar (kawahara option part)
#2304
Originally Posted by royfan33
I just got off of the phone with my LHS and was told my parts may or may not be coming from Team Phenix due to Team Magic switching to Trinity for distribution. I'm not a happy camper. I like the personal touch from Motorman, and 25 years in R/C tells me that when certain large companies get their hands on distribution of rc products, prices go up and supply goes down. I would not have purchased a G4S had Trinity been the distributor 2 months ago.
Motorman put them on the map and this is what happens but we dont know reasons behind it.Maybe otorman can give hes response.
#2305
G4S rear upper arm
i replaced G4S rear upper arm to V-ONE RRR's part (bearing include ver)
for smooth arm moving and easy to change rear camber.
for smooth arm moving and easy to change rear camber.
#2306
Originally Posted by gansei
my engine is GR tuned OS 12TZ 3port. and pipe is 5mm GPX-4(hyper).
GR is korea engine tunning company..
(http://www.grracing.co.kr)
http://pds11.cafe.daum.net/download....d&dncnt=N&.JPG
GR is korea engine tunning company..
(http://www.grracing.co.kr)
http://pds11.cafe.daum.net/download....d&dncnt=N&.JPG
Gansei,
Do you think someone in GR speaks english?
I would love to have an engine like yours!
#2308
Originally Posted by rcrevolution
trinity is back on the g4s scene?
what does this mean now?
more expensive partS? longer shipping times?
less avaibility? I might not get a g4s now
what does this mean now?
more expensive partS? longer shipping times?
less avaibility? I might not get a g4s now
AFM
#2309
Originally Posted by gtrmx
Gansei,
Do you think someone in GR speaks english?
I would love to have an engine like yours!
Do you think someone in GR speaks english?
I would love to have an engine like yours!
[email protected],[email protected]
Gr Racing delivered OEM Tuned engines named by "Zeppin racing" in "http://rc-mushroom.com"
But now.. it is out of stock..
#2310
Tech Master
iTrader: (10)
Originally Posted by royfan33
I just got off of the phone with my LHS and was told my parts may or may not be coming from Team Phenix due to Team Magic switching to Trinity for distribution. I'm not a happy camper. I like the personal touch from Motorman, and 25 years in R/C tells me that when certain large companies get their hands on distribution of rc products, prices go up and supply goes down. I would not have purchased a G4S had Trinity been the distributor 2 months ago.
I had the first G4 under trinity. I sell it 2 month after my crash. NO PARTS SUPPLY at all
Trinity SUCKS