Hicksey

I am new to all this so excuse me if i dont know wat other people are talking about. anyway i have a XB tamiya subaru wrx 04 with a tg-10 engine and i have a nissan R34 boby shell. i havnt cut the nissan shell yet i dont know how to. so reply if you could give me some tips please

thankyou Hicksey

drfritz

http://www.hpiracing.com/graphics/tips/paint.jpg
try this

Hicksey

thanx but how to cut out

Rapid Roy

I'm assuming that you arn't doing any sanctioned racing here. Cut about 1/2 of the front windshield in directly in front of the engine. Cut most of the rear window out and cut out both side windows. Make sure you keep the corners rounded. A square inside corner will cause the body to tear when or eventually break when the body flexes. Also don't cut the vent holes too close to any other holes for glow plug or pull start.