lagos

the xray caster blocks dont fit inferno style suspension ok , they fit on JQ , but you have to use caster block + hubs + xray universals + ballbearings ....
with this combo , i felt the car was sheet with front tires and continuous with a good corner entry and corner speed ...

lagos

I would greatly appreciate if anyone had any information from other models of 2 speed transmission gears which can also be used ... The JQ yellow chassis is very tight , but offers adjustments on engine position end central diff position that helps a lot ... as I only have the kyosho 2 shoe type model that i like a lot , I stuck to it in car conversion ... any tip is very welcome ..

ferrariGTR

Hi lagos, thank you for sharing your excellent mod and congratulate to your win.

I've been thinking to custom mod a 2 speed transmission and would like to seek your help for some measurement below:
1. length of the 2 speed shaft (part no. KYOIGW008-01)
2. diameter of the 2 speed shaft
3. outer length of shaft measure from drive cups end to end (measurement A of pix)
4. inner length of shaft measure from bearing to bearing (measurement B of pix)
5. Thickness of bearing



I appreciate very much if you could help me out on these measurement. TIA

lagos

i`ll take the mesurements for you ok ... and iŽll try to take some other pics to show details too ok ... see you

Fluke

bumping this up because i'd like to know the mesurements as well

n.e.r.d

iTrader: (6)

Hi Lagos, I'd like to know the measurements of the IGT 2 speed transmission too..
Will be waiting, thanks!