i just got a kawaharra chassis. it is 3mm, and it doesn't look like it is machined
can someone confirm weather the kawaharra pro chassis is machined or not?? the standard mugen chassis bends very easily. i was after a 4mm machined chassis with the countersunk baulkheads so it has the original roll centre. does anyone make a chassis like this (something like the mtx3 prospec chassis)
i just purchased VXR car battery and 5 amp regulator. i used it with the following setup without issues:
-futaba s9550 steering servo
-sanwa VX throttle servo (high toRque! 13kg!)
i connected the capacitor and 5 amp reulator to the Y lead. this is on a mtx4.
there is enough room in the car to fit the battery, Y lead capacitor and 5 amp under the tank. i will be doing a modification soon to fit the regulator on the exhaust side of the car so i can lower the tank.