Kyosho v-one rrr
#9722
Hi, anyone faced any problems with the front diff case hitting the pushrod plastic from the servo saver ? Any work ideas how to fix this ?
Dremel is out of the question makes the diff leak and steering rods to weak.
Thanks
Dremel is out of the question makes the diff leak and steering rods to weak.
Thanks
#9724
Tech Adept
#9725
Ramiel yes I am, I also checked the manual of the EVO RRR WC it is using the small ball ends with the small ball end metal studs as opposed to the screw type ones that come with the RRR EVO WC
#9726
Tech Adept
#9727
Okay the way to go, any ackerman, just use ball ends with ball cups and problem resolved.
Had a test run today, awesome setup, will need a little more getting used to it, since i have been out of it for such a longtime.
My setup
Front
30K
500w
2camber
toe out 1
droop 0
40 shore
Medium springs
Ride height 4
Back
10k
500w
3camber
toe in 3
droop 5
38 shore
medium springs
ride height 5
Stock gear ratio and clutch spring set at 0.6mm with sirio evo Sti
Will need to work on the caster a little, increase the ride height that straight had a little bump nearly flew the car off, nice spark though.... was way to low to drive.
Overall very very nice good to be back at it again.
Had a test run today, awesome setup, will need a little more getting used to it, since i have been out of it for such a longtime.
My setup
Front
30K
500w
2camber
toe out 1
droop 0
40 shore
Medium springs
Ride height 4
Back
10k
500w
3camber
toe in 3
droop 5
38 shore
medium springs
ride height 5
Stock gear ratio and clutch spring set at 0.6mm with sirio evo Sti
Will need to work on the caster a little, increase the ride height that straight had a little bump nearly flew the car off, nice spark though.... was way to low to drive.
Overall very very nice good to be back at it again.
#9732
Robert maestrey