Originally posted by CHUCKMANDO
Is there any other quick building tips I should know about?
Thanks in advance.
*When mounting the steering servo horn, mount it onto the servo at about 11.30 hours (no, not at that precise time, but a fraction to the left of dead upright
).....mounted in this position you shouldnt even need any trim if everthing else has been done correctly.
*Oil the shock collar o-rings, this`ll make them run heaps smoother.
*Mount the front anti-roll bar flat.......vertical gives too much understeer.
*The front castor may have a bit of "play" in it once all the castor clips are mounted. To get rid of this play use a 1mm castor clip in addition to the ones supplied (NTC3`s are 1mm if you cant find a Kyosho 1mm castor clip).
* If youre building a non-WC RRR, get the aluminium brake hub holder to sue when you build the car (VZW205)
* If youre running a Protoform Mazda 6, mount the rear body posts on the inside of the shock tower....that way they wont come up underneath the rear wing.
* Dont over tighten the fuel tank mounting screws onto the upper deck.....these need to be free.