Mugen Pro Starter II w/4s Lipo Help
#1
Mugen Pro Starter II w/4s Lipo Help
Anyone have a Mugen Pro Starter II box and installed a 4s lipo? Looking for the correct diagram to install the lipo. Since the box has 2 tamiya connectors for the two nimh batteries. Any help would be greatly appreciated...
Jay7...
Jay7...
#2
Tech Initiate
iTrader: (2)
Dear
I installed 2 lipos in off road and on road Mugen starter boxes.
You should check the room of starter box for installing a new lipo battery.
I attacted 2 pics for you.
One is a off road and another is a on road.
I bought 2 lipos from Hobby King.
On road's room is smaller than off road starter box.
So I installed a 3300mh lipo for on road.
I put a 5000mh lipo in off road starter box.
Lipo size is depended on its capacity.
My friend installed a pro teck lipo which is a small size but its capacty is around 1650mh but it is so good for starter box and reduces the weight of starter box.
I am lazy so I need bigger.
It is easy but be careful. You only use iron and solding..
Connector is simple and you only check + , - .
Last edited by csterikim; 04-23-2011 at 03:38 AM.
#4
Bat + to motor 1 + . Jumper from motor 1 - to motor 2 +
Bat - to switch. Other side of switch to motor 2 -
Bat - to switch. Other side of switch to motor 2 -
#5
Thanx for the help...