Originally Posted by Care
Very interesting Question you are asking. I have exactly the same challenge, I want to convert my old but great Super Ten to brushless. Unfortunatly I didnt find a single overview how to do this and which are the right parts to use.
Could you please do me the favor and give me a inside what you figured out.
Thanks in advanced for your support,
i have converted my fw04 to bl with mid diff !i havent complete it yet cause im waiting a carbon fiber sheet so to make some carbon parts !
I am just about to take some photos maybe tomorrow !
For the conversion i have use
1)motor mount from ofna sc10
2)mid diff with diff mount from kyosho dbx
3)center drive shafts(cvd) that is a mix from ae rc8 center cva input cup
and thunder tiger mta4 drive shaft (only the axle)
4)Battery case from ofna sc10
5)39t spur gear from kyosho tr15
To fit all the parts (motor,battery case etc ) i have already place the servo saver from the left side to the right side thats because the battery case is sitting in the left side of the chassis so no room left for the st servo!
The only thing that i have to do is to cut a c/f sheet and make a new upper deck and center diff plate!
If everything works properly i ll use a robitronic platinum bl motor thats a 550 type motor turning at 3400 rpm per volt ..
I'll be back with more info and photos...
Best regards from greece.