im finding it difficult to remove wristpin off conrod
#1
im finding it difficult to remove wristpin off conrod
I'm finding it difficult to remove wristpin off conrod this is the conrod clip I have below.
http://www.google.co.uk/m/imgres?q=n...ed=0CAoQ9QEwAA
Thanks
http://www.google.co.uk/m/imgres?q=n...ed=0CAoQ9QEwAA
Thanks
#2
And again a new topic andagain not in the engine section..... You can use one of your P/S topics to go further with this question.
But OK,
You have a Collari 35+ with a sleeve through the hole of the pistion pin ?
If so, you can use a needle to wip out the clip. If you have problems to pres out the pin you can use cleaning putty to lay the piston on and plase a 1.5mm hex driver through the open site of the pin to hammer out carefully the pin.
But OK,
You have a Collari 35+ with a sleeve through the hole of the pistion pin ?
If so, you can use a needle to wip out the clip. If you have problems to pres out the pin you can use cleaning putty to lay the piston on and plase a 1.5mm hex driver through the open site of the pin to hammer out carefully the pin.