nitrotmaxxw/.19

i got my dynimite .19 engine i broke it in as instructed then it got hot out side the next day i tryed to tune it but failed it was spiting fuel out of the pipe on the factory settings and wouldn't start i tryed to lean it off but no luck can someone give me the factory settings or some tips??? thanks

LiL_JaSoN

iTrader: (6)

glowplug...

nitrotmaxxw/.19

tryed that.

mugenize1

iTrader: (-1)

Sounds like you very rich if the pipe is spitting fuel. Try this put the bottom needle flush then turn it in 1/4 turn in, put the top needle 2 1/2 turns out from closed you should be able to get it started with this setting hope it helps,

JetMD

iTrader: (1)

+1 for it's rich. Also, pull the pipe off and dump out the oil. Might be filled up which won't let the motor run. Good luck.

nitrotmaxxw/.19

just pulled off the pipe and a ton of fuel came out hopeing that was my problem..

nitrotmaxxw/.19

still not running anymore ideas??? im think of throwing this thing in the trash

skydark_34

check ur throttle opening first,adjust low end needle flush then turn it in 1/4 turn in, adjust the high end 2 1/2 turns out from closed and try again.check ur glow heater an see if it cooks with enough heat.