chris246810

hello i was just cleaing my engine with after run oil and i pulled the pull stater a couple of time then it just wont pull any more can it be damaged,broke or is it just flooded? i would like to knwo cause i am ordering some parts for my car and woul dlike to order that piece if i need it.
write abck

maseeh

Try loosening up the pull start screws.

chris246810

ok heres the deal i just took off the pull start and that works great. not i put it back on the engine and it wasn't puling so i looked where the pull start connects to through the engine and i tried to turn it with my hand and it wont turn so wht can be wrong with the engine what wont let it turn over.

subman

iTrader: (4)

pull out your glow plug and pull it, this will relieve the back pressure. Try and let us know what happens.

chris246810

nothing happens it actually feels like the motor is jammed.

Smoke21

sounds like you flooded it with AR oil, take the Glow plug out and hold the car upside down hopefully most of the oil will come out, if not that your piston and sleeve may be stuck let us know

chris246810

i tried turning it upside down and nothing came out. should i go head and check my pistion ?

chris246810

my piston was stuck on somthing but i got it loose but have to buy a new rcoil starter. thanks for your help . does that usally happend with the piston. and what usally goes bad (breaks) alot on a nitro car? belts,breaks,tires,etc etc.