MUGEN SEIKI MRX5
#691
Tech Adept
#692
In answer to your question the mrx5 starts at $600 upto 750.00 for a prebuilt one from mike swauger.
Ralphie see you in the morning to test the mrx5 ! hope to take some video and have it posted here tomorrow night .
brooklynhobbies.com
team mugen northeast
nyrclive.com
Ralphie see you in the morning to test the mrx5 ! hope to take some video and have it posted here tomorrow night .
brooklynhobbies.com
team mugen northeast
nyrclive.com
#693
Tech Elite
iTrader: (36)
#694
See that part in his signature that says www.brooklynhobbies.com , I'd try there.
#695
Tech Adept
Any suggestions about sevros&battery receiver for MRX5?
Thanks
Thanks
#696
Can someone tell me what are the size of the pulleys are they the same as the 4X
#698
a must have mod / no touch
#699
car before run
#700
car after 1/2L run
because i'm using an old shell (P909 from Vx) with the standard setup, the car feel easy to change diretions (with 25mm bumper to shell) then change front upper arm post to 5mm at the back, car feel very stable to drive next time will try 18/20mm bumper to shell. another thing was the two screws of the saver are easy to loose, must use t/l or wait for the alu one
because i'm using an old shell (P909 from Vx) with the standard setup, the car feel easy to change diretions (with 25mm bumper to shell) then change front upper arm post to 5mm at the back, car feel very stable to drive next time will try 18/20mm bumper to shell. another thing was the two screws of the saver are easy to loose, must use t/l or wait for the alu one
#701
just check from the lap record, the fastest lap that i made compare to the old/new car was improve .3 sec i'm looking forward to the rest
#702
#703
Is it for the one piece low engine mount?
#704
Tech Adept
any suggestions for sevros and battery for the MRX5?
#705
Tech Regular
servo saver
Another helpful hint i hope helps during the build . the servo saver /ackerman piece is adjustable , and if you move all the way up it will rub the one way pulley . If you dremel away the turnbuckle plastic end near where it passes the one way pulley you will be able to use the adjustment to it full potential .
Richard Siriano
Team Mugen Northeast
Richard Siriano
Team Mugen Northeast