Originally Posted by omegaf
yea, i found out about schumacher a few days ago. i will definitely order from them. i am trying to make a list of parts i will need first. i am still kinda lost.
for starters i don't even have loctite yet and i don't know if it will be needed. i also don't know what filters to buy and what exhaust. things are starting to get a bit complicated
so do i need a fuel filter? and what size engines are compatible with 1/10 nitro chassis?
Only look for .12 racing engines with a rear exhaust and non pullstart.
Ok here it goes, everything you will need:
Engine, Exhaust and accessories:
Novarossi N12T1 (same as jas1 showed
Novarossi 2601 exhaust with a short header
Fuel filter isn't necessary as there is already one in the tank.
Air filter, the Xceed INS box with filter http://www.xceedrc.com/product/103009
Starterbox, I have the LRP one and it's very good. But if I had to buy one right now I would go for the Hudy box.
You will need two 7.2V Nimh stickpacks for the starterbox or one 4S lipo.
Glowstarter, isn't a specific brand I would recommend, they all seem to do their job.
Fuel bottle: http://www.capricornrc.com/capricorn...d_product=1272
And some fuel off course, don't know which brands are available in the UK but I would recommend Runnertime or Capricorn fuel since those are the best.
Loctite, I would recommend Loctite 248, makes for easy application.
Receiver battery, Nimh or Life.
Wire extension for the batter connection: http://www.electricwingman.com/produ...x?product=1426
Glow plug wrench, to place and remove glowplugs and tightening the flywheel nut: http://www.hudy.net/xhudy/products/p...&kategoria=538
Camber gauge, so you can set the camber on your wheels: http://www.xceedrc.com/product/103033
If you don't have them a set of calipers and a steel ruler.
Some double sided tape to mount the battery and receiver.
Glue for the brakepads, the kind of glue which you apply to both surfaces and bond them together after the glue has dried for 15 minutes.
Only able to find dutch sites: http://www.bison.nl/NL/nl/view.do?UI...c2c7dd2dc07ba0
-1.5 2.0 2.5 3.0 hex wrenches
-4.5 5.0 7.0 nut wrenches
-Some sidecutters and pliers
-Grease for the driveshafts and clutch bearing: http://www.capricornrc.com/capricorn...d_product=1178
If you want a painted body already trimmed for the Lab I could send you this one since I won't be using it, never been run:
When interested contact me by PM.
I'm not sure if this list is complete but it should get you started.