Mono Tuning Tires....Great new Tires!!!
#78
Sorry , they are only available in zero (standard). What car are you running that needs 2mm offset , if you dont mind me asking.
#79
Tech Elite
iTrader: (2)
Hi ron it is a yokomo I'll figure something out on fitting because
these tires work good and i noticed everybody that ran the
monotuning tires were still running good lap times 30 mins into
the main because thier tires wore down 1 to 1.5 mil at most
compared to my kawahara that went through 3.0 mil
at the end of the race.
these tires work good and i noticed everybody that ran the
monotuning tires were still running good lap times 30 mins into
the main because thier tires wore down 1 to 1.5 mil at most
compared to my kawahara that went through 3.0 mil
at the end of the race.
#80
Tech Addict
iTrader: (11)
I agree with ya, I ran a 30 minute main this past weekend and only wore about 1 mm . It was a little less than 1 . That is just amazing . Also my car never faded. Is the axle long enough to put a 1 mm spacer behind each wheel ? this will get you half way there. Try kyosho # vz013 it is a wheel shaft that moves the wheel out 2 mm farther. this is how it is done on the FW-05R.
#82
Super Moderator
iTrader: (239)
Originally posted by ATOMIC
I agree with ya, I ran a 30 minute main this past weekend and only wore about 1 mm . It was a little less than 1 . That is just amazing . Also my car never faded. Is the axle long enough to put a 1 mm spacer behind each wheel ? this will get you half way there. Try kyosho # vz013 it is a wheel shaft that moves the wheel out 2 mm farther. this is how it is done on the FW-05R.
I agree with ya, I ran a 30 minute main this past weekend and only wore about 1 mm . It was a little less than 1 . That is just amazing . Also my car never faded. Is the axle long enough to put a 1 mm spacer behind each wheel ? this will get you half way there. Try kyosho # vz013 it is a wheel shaft that moves the wheel out 2 mm farther. this is how it is done on the FW-05R.
I will let you guys know how the tires did on Sunday night.
Aaron i will let you know too!!
#84
Originally posted by ATOMIC
Sorry , they are only available in zero (standard). What car are you running that needs 2mm offset , if you dont mind me asking.
Sorry , they are only available in zero (standard). What car are you running that needs 2mm offset , if you dont mind me asking.
i think MTX3 needs 2mm offset
#85
I run them on the MTX3 with no problems at all.
#87
really?? that's cool
do you ship to canada?? on the web it says shipping method is not avaliable for the country (canada)
do you ship to canada?? on the web it says shipping method is not avaliable for the country (canada)
Last edited by Fire; 03-31-2004 at 01:17 PM.
#89
Originally posted by ATOMIC
shoot me an email with your # and I will give you a call and ship you some. [email protected]
shoot me an email with your # and I will give you a call and ship you some. [email protected]