rcpaintinpete

iTrader: (16)

DID NOT see you this weekend whats goin on

shamu

When assembling the diff one of my outdrives binds in the diff housing when you rotate it.I cant find what is causing this the part looks fine and I dont see any flashing in the housing.will this wear in or am I missing something?

quietstorm76

iTrader: (12)

Make sure the center screw that holds the bevel gear is not backed out and also thread lock this screw. it will vibrate loose and bind like hell if you don't.

shamu

the diff is not together yet ,the bevel gear has not been attached.I insert the outdrive into the housing and when you rotate it, it starts to spin freely then binds.this is only on one half the other half is fine.

trickd122

iTrader: (3)

Yeah, I had some stuff that I had to take care of and also my homie Wayne wasn't going to make it either. I figured that you guys would represent us well and you did so. My presence was not neede after all.

On a second note I heard the track was alot of fun. The recent changes made the track more High speed and flowing.....funny though the laptimes are basically the same

trickd122

iTrader: (3)

During the manufacturing process sometimes there is excess material left over inside the diff case. This is NOT a problem however, you can use an xacto knife of something of sorts to remove or just run it in.

and23

http://www.unoadieci.com/prodotto.cf...0-b3f820b2601a

rcpaintinpete

iTrader: (16)

what are the stubs for?

Team Kamikaze

iTrader: (3)

The picture shown are 903257 Uprights for the 966, not for the 733.
Here: http://serpent.com/product/903257

quietstorm76

iTrader: (12)

It won't just spin freely because of the x-ring that goes onto the outdrive once it's inserted. You checked for flashing in the diff housing? Tried switching the outdrive to the other side?

rcpaintinpete

iTrader: (16)

HEY GUYS have 2 733 bodies for sale
one is cut and fitted the other is not
and one 966 body fitted
60$ each or 150$ for all 3 bodies
yes these were DJ's bodies
we have changed up his paint schem
and will not be using them

shamu

There is no flashing in the housing, it must be defective because the outdrive spins freely in the other housings,i'll have to order a new housing bummer!this is holding up my build.Thanks for your help anyway.

quietstorm76

iTrader: (12)

are you saying that you can't turn the outdrive at all? Is it stuck? It can be a little tight and be ok.

rcpanama

Hi, does anyone knows what is the position in front of the center post from body position in the Blitz Altis

Thanks

RCPANAMA

Serpent-Dan

iTrader: (18)

27.5mm sits right at the center of the wheel wells. I run mine at 27mm