Ofna Tire Truer Question
03-20-2008, 05:38 PM
#1
Ofna Tire Truer Question
NEVER MIND....I JUST FIGURED IT OUT...DUH!
I picked up a real nice used Ofna manual tire truer....wow, impressed so far!
This is the first one I have ever used so I have nothing to compare it to or I could probably answer my own question as it is pretty simple I am sure.
My question is...the cutter is in a horizontal position and it seems to me it would cut the tire surface cleaner and better if it was set at a slight angle.
I can not see where there is any adjustment to rotate the cutter at all????
I picked up a real nice used Ofna manual tire truer....wow, impressed so far!
This is the first one I have ever used so I have nothing to compare it to or I could probably answer my own question as it is pretty simple I am sure.
My question is...the cutter is in a horizontal position and it seems to me it would cut the tire surface cleaner and better if it was set at a slight angle.
I can not see where there is any adjustment to rotate the cutter at all????
Last edited by genesisG4; 03-20-2008 at 06:17 PM.
03-20-2008, 06:33 PM
#2
Not sure about the manual cutter. But the Ofna auto truer the blade is mounted at a 45 degree angle. If you look at the cutting arbor there should be a thumb screw on the top that drops down into a milled slot on the cutting arbor. This places the cutter at a 45 degree angle.
Race you later...
Race you later...
03-20-2008, 07:00 PM
#3
Not sure about the manual cutter. But the Ofna auto truer the blade is mounted at a 45 degree angle. If you look at the cutting arbor there should be a thumb screw on the top that drops down into a milled slot on the cutting arbor. This places the cutter at a 45 degree angle.
Race you later...
Race you later...
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
