Tc3 Won't Shift Please Help
hola everyone
I have a ntc3 and i just got it running. The only problem is, i can't get my 2 speed to shift. I have it on all of the stock settings, but the darn thing won't shift. I took it apart, and i couldn't see anything wrong. PLEASE HELP cejota :tire: |
Loosen the adjusting screwsa about one half a turn, it is the adjustmment that is on an angle. Stock is 3 1/2, I think. Make sure you remember which one you adjust, they are numbered, so that you don't do the same one twice.
|
Check to make sure the balls are evenly pressing againt the flats on the shaft
|
Re: Tc3 Won't Shift Please Help
Originally posted by Cejota hola everyone I have a ntc3 and i just got it running. The only problem is, i can't get my 2 speed to shift. I have it on all of the stock settings, but the darn thing won't shift. I took it apart, and i couldn't see anything wrong. PLEASE HELP cejota :tire: |
Getting that thing to shift was the biggest problem I had with the kit. Make sure that you deburr the shoes and look inside the screw holes to make sure there isn't anything that will bind up.
|
Rebuild the 2 speed housing
|
Back the 2 set screws on the 2speed out 1/2 to 3/4's turn from the stock setting. Make sure you adjust the right 2 set screws. Alot of non shifting 2speeds on the NTC3 I have seen was from not adjusting the right set screws.
|
All times are GMT -7. It is currently 03:51 PM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.