not sure if this is the right section to post it in but I have a problem ....
hey guys ...
I have bought the USB VRC RC Car Model Simulator
but the problem is I can only control one channel!!! it has two connectors, but only one connector has three wires to carry the signal. The other three pin connector has only one wire??!!! is this correct? I tried every possible combination but no luck.
When I go to calibrate scree, no matter how I connect the 3 pin connector that has one wire, it does not work.
The car obviously needs two channels, one for steering and the other one for throttle and break. How am I supposed to control it with one channel only ????
Can someone explain what am I doing wrong or if this usb vrc is one channel only ??? why would they even make one channel ???
please help !!!