Anybody else notice a slight scraping of the trigger on the 3pk?
I purchased a new 3pk and have noticed the the trigger scrapes the right side of the case. Its a very slight scraping and I cant really feel it but I can hear it (when its quiet). I was just wondering if anybody else experiences this, I emailed futaba and they said I should send it in for service but I think I might have exaggerated the extent of the scraping. Another 3pk owner on the RCCA forum said they experience this too and that they put a little silicon spray on it and it went away, at least temporarily. So could anybody who owns the 3pk do me a favor and just put their ear by the trigger and listen and see if they hear a slight scraping noise. Im just trying to figure out if its like this with all 3pks or if its a defect that only me and the other guy have.
Thanks heres a picture of where it scrapes: http://www.imagestation.com/picture/...2/fbdc9bb2.jpg |
My 3PK doesnt scrape. The only problem I have had is I have lost
1 line of the display screen. The radio works fine but I need a new screen. |
no scraping... but i've experienced switching on the radio and getting a totally blank screen, then i would need to switch it on and off again. I've seen quite a few of these problems in my area with the 3pk
Other than that, i still love the radio... |
All times are GMT -7. It is currently 03:31 PM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.