Hudy automatic tire truer blade.
#1
Tech Regular
Thread Starter
Hudy automatic tire truer blade.
Yo fellas i have a hudy tire truer, my blades dull and i want the the carbide blade but cant find one, i was told that i can use an alternate blade made from a hacksaw blade if this is true which blade to use. All help is appreciated thanks...
#2
this is true, seen it work pretty well, not quite hudy but good.
do a search, i know sorry
there was a big thread about a month ago all about it
do a search, i know sorry
there was a big thread about a month ago all about it
#3
Tech Elite
iTrader: (89)
The Blade you want is a JIG saw blade not a hacksaw blade. Your looking for a 24 TPI Bosch or Porter and Cable blade. I would install two of them with the blade teeth opposing one another. This configuration gives an awsome cut. I believe just as good as a hudy. The single blade will leave lines in the tire.
hope this helps
hope this helps
#4
Tech Regular
Thread Starter
Blade
I guess i would remove the old hudy blade and use it as a template to make the new blades correct or does it matter.?.
#5
Tech Master
I have a friend that cut the end off of a Mico tire file, and uses it in place of the cabide cutter. It works freaking awsome.
#7
Tech Elite
iTrader: (89)
I would put the blades on and true a fresh tire to around 62mm based on the dial settings. Whatever its off by use a dremmel and grind the back side of the blades until its the correct depth. Now if you have a Hudy truer by all means just replace it with a Hudy blade. I have a Hudy blade but it takes my truer almost 2.5 mm out of calibration on a Ofna truer.
#8
i like hacksaw blades
the ones with the most teeth per in
i dont like the hudy bit why you ask,it gets dull and its $50.00 what a waist of money.
to me anyways.
the ones with the most teeth per in
i dont like the hudy bit why you ask,it gets dull and its $50.00 what a waist of money.
to me anyways.
#10
i had a hudy bit and took it off and sold it to someone that wanted it.
and now they to just use hacksaw blades.
#12
#14