Mugen MTX-4R
#3661
#3662
Tech Initiate
Not sure about nt1 tranny but tironi from italy uses sirio clutch and fukuda from japan has used xceed (sames as serpent) clutch also, both are direct fit with the offeref cltuch bell, as for the nt1 you can use it directly with some shims and spacers between the two speed housings with no issues at all, ive tried it and it works and if you can get a lowered engine mount better as these centax are all of them smaller than mtx stock one (1mm lower)
but I would like to know, if they use original trany parts - so internal ratio, or they use some different parts to change ratio and also rotating mass.
#3663
Im not sure but by looking at he pics from redrc.net i saw no change in the tranny ratio at least on the 4 mugen drivers that reached the final, but i bet it is possible with some modifications
#3665
A few MTX4 bits I am selling on flea bay for anyone that might be interested....
http://shop.ebay.co.uk/getpip/m.html...&_trksid=p4340
http://shop.ebay.co.uk/getpip/m.html...&_trksid=p4340
#3666
Tech Initiate
But that was that I expected to receive here :-) See I think MTX4R is good car even a bit old, but new informations and experience still appears and are involved in new constructions. So there is no surprise somebody change a bit this and a bit that to suits him or to track better. Not only to Mugen - how many drivers shortened their front on WC, Drew offered lot of very interested informations for NT1. Also for 733 and DLS appears something.
#3667
Novarossi Challenge @ Homestead Super Raceway
#3668
Tech Initiate
Setup from WC
Did you find setup for MTX4 that guys used on WC? I googled a bit without success. Maybe somebody knows something more?
#3671
hi
what are the differences between the open class and the sport class?
what are the differences between the open class and the sport class?
#3672
Tech Rookie
Help
Hi,
Some body has experienced with the use of rear solid axle and front solid or looked one way?? how´s the effect on handle
Some body has experienced with the use of rear solid axle and front solid or looked one way?? how´s the effect on handle
#3673
Tech Elite
iTrader: (17)
A sick mtx4r available guys. This thing is the crown champ.
http://www.rctech.net/forum/r-c-item...build-rtr.html
Letting it go for insanely cheap...mention your a participant in this thread and ill send over some backup parts which some maybe upgrades new in box...most likely from skyline.
http://www.rctech.net/forum/r-c-item...build-rtr.html
Letting it go for insanely cheap...mention your a participant in this thread and ill send over some backup parts which some maybe upgrades new in box...most likely from skyline.