Mugen MTX-4R
#3377
Tech Master
iTrader: (13)
Front diff
Well, I assembled a front diff but when I tried to install it, I found that it is too wide. It's as if the shoulder that the right bearings sits next to needs to be machined down so the bearing can move about 2mm towards the middle. Anybody got a better solution?
#3380
are the eccentrics in the right position?
#3384
Tech Initiate
iTrader: (2)
diff cups
Does anyone know which diff cups to use and the part numbers for the washers for making a front diff? I was just trying to order the parts but came up with two different part numbers mugt0261 or mugt0277. The manuel says mugt0261 but i do have the original mtx4.
Ryan
Ryan
#3387
Tech Initiate
How many you guys planning switch away from mtx4 to the new car that coming out recently?