Mugen MTX-4R
#2612
How i can protect my receiver,instead of that plastic cover... is there any box or something like that??? like xray has?
#2614
I use the xray box, works great.
#2615
I too use the NT1 box....
#2616
Thats perfect!!! I thought about that but sounds wired!
#2617
oups....and fits as is?? no holes no anything?
#2618
Fits without modification, although you will probably need to make a hole for the wires to exit....
It mounts the other way round to the xray (wider edge outwards) this is obvious when you come to fit it.
Dont forget to order the rubber bung for the crystal window.
It mounts the other way round to the xray (wider edge outwards) this is obvious when you come to fit it.
Dont forget to order the rubber bung for the crystal window.
#2619
Have you done this yourself? And absolutely sure of everything you just typed?
#2621
#2622
Nuff said?
#2623
my car has a problem: front upper arms has a lot of play like i forgot to put one of the caster clips to the pin. a lot of shims are needed to eliminate this. Did it happen to you? I changed the arms but it didnt solve the problem.
thanks in advance
mustafa
thanks in advance
mustafa
#2624
stefan: nice , mine look sjust like yours, even the cf sticker to cover the x-ray
I use shims to take the play out of upper arms, just make sure you shim the same front and rear so you don't change the caster
I use shims to take the play out of upper arms, just make sure you shim the same front and rear so you don't change the caster
#2625
I have my boxes on order. The picture are copied from on older post in this thread...