What is this used for?
01-31-2007, 01:54 PM
#1
What is this used for?
My "new to me" MRX-3 came with a new Racerchoice lola body. It came with these odd parts and no instructions as to what they are used for.
5 lengths of plastic and a bag of rivets. Please see pic...
5 lengths of plastic and a bag of rivets. Please see pic...
01-31-2007, 02:00 PM
#2
You dont know what they are for? 
The 4 little pieces are the body stifferners & the other is the wing.
The body stifferners need to be bent at the lines marked then attached to the body with the rivets, behind the front wheel & in front of the back wheel. You should know where the wing goes.
The 4 little pieces are the body stifferners & the other is the wing.
The body stifferners need to be bent at the lines marked then attached to the body with the rivets, behind the front wheel & in front of the back wheel. You should know where the wing goes.
01-31-2007, 02:47 PM
#3
Gracias...
Sorry for my ignorance and "newbness" but I have only dealt with touring shells in the past...
Sorry for my ignorance and "newbness" but I have only dealt with touring shells in the past...
01-31-2007, 02:54 PM
#4
Originally Posted by BIGTACO
Gracias...
Sorry for my ignorance and "newbness" but I have only dealt with touring shells in the past...
Sorry for my ignorance and "newbness" but I have only dealt with touring shells in the past...
Thanks
Loren
01-31-2007, 03:05 PM
#5
Originally Posted by BIGTACO
Gracias...
Sorry for my ignorance and "newbness" but I have only dealt with touring shells in the past...
Sorry for my ignorance and "newbness" but I have only dealt with touring shells in the past...
01-31-2007, 03:11 PM
#6
hehe...oh I will. Lets just hope I can stay off the ways 
01-31-2007, 08:29 PM
#7
There's also a whole article on the Serpent website about how you can use the stiffeners to make the rear of the body slightly wider than the front, thus being more aerodynamic.
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
