Help pls with starting new nitro.
i can pull the starter and get the engine to start and then it stalls when i take the ignitor off. what do you think can be the problem too rich? fouled glow plug? any help is appreciated. thanks.
|
If the engine is new, next time you get it fired up, while it is running, lean out the high speed needle by a quarter of a turn (to the right). Then you will let it idle for a while. Start with that, then maybe adjust the idle screw.
|
I would adjust the idle spd needle 1/8 inward and start wif the ignitor on for a few second before pulling out for cold start. once its warm i'll put it back to it original position. n did the same for which warm up start to my car each week. Everyone has its preferred ways to get the car start but maybe some other can giv u a better advice :)
|
YOUR PROBABLY TO RICH,LEAVE THE IGNITOR ON IT TILL IT WARMS UP.WICH MOTOR IS IT?THE FACTORY SETTINGS ARE USUALLY VERY RICH,SO LEAN IT ABOUT 1/4 TURN
|
thanks guys i was a little too rich.
|
All times are GMT -7. It is currently 12:07 PM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.