help for my hpi rs4-2
hey guys im new here and i have a problem with my r/c
i have a hpi nitro rs4-2 it has a 2spd tranny, mip exhaust and high performance heat sink my problem is that the screw on my carbureator(is that how u spell it?) is gone/loose. i found it and i tried to put it back in the hole but it moves in and out so easily. it seems that i cannot screw it in anymore, and the spring just pushes the screw out. it seems that my r/c wont start because of this problem do any of u guys have any suggestions on what i should do?? thanks in advance |
What type of engine do you have? Are you talking about your low speed needle? A little bit more information is needed here.
|
its a nitrostart 15fe engine. it is the idle adjustment needle. it is very loose and easily pulled out.
|
Sounds like the threads are stripped. Not much you can do , even a larger screw won't help as it has to be keyed to the carb. You can try any of the many "rethreading" products out there , or get a new carb or upgrade the whole engine. A 2nd hand carb shouldn't cost too much and fairly easy to come by. Maybe someone on the boards would be willing to mail you one. :nod:
|
All times are GMT -7. It is currently 01:28 AM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.