TLR 8ight-T 4.0!
#31
Tech Master
iTrader: (6)
Hey, so i plan on purchasing one of these beautiful machines when they are released, but ive never run an imperial car so have no tools, aside from the regular 3 drivers do i need anything else, like nut drivers or wheel nut spanner etc etc or will all my metric stuff work except the drivers.
Thanks all
Thanks all
#32
Tech Elite
iTrader: (36)
Hey, so i plan on purchasing one of these beautiful machines when they are released, but ive never run an imperial car so have no tools, aside from the regular 3 drivers do i need anything else, like nut drivers or wheel nut spanner etc etc or will all my metric stuff work except the drivers.
Thanks all
Thanks all
3/32" and 1/16" allen drivers,
The standard 2.0mm allen is used for the 5/64" sizes.
Wheel nuts are still the normal 17mms...
Have not come across any other tool "required to have" for a Losi that did not work on any other vehicles...
#33
3/32 MIP ball driver.
#36
Tech Regular
Are there any metric conversions for the car? and would it be worth the money?
#38
Tech Elite
iTrader: (36)
The truck isn't even out yet.... Give it some time
#39
Tech Elite
iTrader: (103)
Can the Losi e conversion be used with the nitro 4.0T??
e conversion... http://www.horizonhobby.com/LOSA0912...9lvw_wcB#close
e conversion... http://www.horizonhobby.com/LOSA0912...9lvw_wcB#close
#40
Tech Regular
There were a couple kits that were metric heads with standard threads but that was back in the 2.0 days ( marketed for the EU mainly) that may still be out there. I think it was Tony's or RCScrews.... But for the $40-45 in screws plus shipping to down under, you could get the 4 tools you need, soooooo......6 in one hand, half dozen in the other
#43
Damn. I was getting excited cause on amain it said the kits would be arriving on the 6th. Looked last night and it has been changed to the 20th.
#45
Not for $899!