1evo RRR Driver

iTrader: (11)

Fellas Im at the point where its time to replace my D8 Hara chassis, and I was interested to kno if theres a chassis that was better than the 3mm lightened one the buggy came with? If someone who has used all 3 of these could shed some light, it would be much appreciated!!!!!

HARA VS BCE VS FIRONI what should I get???

1evo RRR Driver

iTrader: (11)

Damn! People 100 views and no info......smh

NITROALM

Hey RRR YGPM

ROSCOE

iTrader: (130)

Don't forget about the TEKNO. Ran one for a while on my D8 with good luck. Chassis wear is awsome and seemed to lock in rear more yet.

willbe

iTrader: (5)

http://www.rctech.net/forum/nitro-of...ml#post9350216

Hara Forum: Jesse Robbers answers your question.

I have used the Fioroni for over a year with minimal signs of wear.

garen

iTrader: (7)

I can only speak for the Fioroni chassis; Both Tessman and Robbers have or are using them and both have given it the thumbs up.

offr0aden

iTrader: (6)

I've used the BCE 3mm D8 chassis. And its very durable and doesn't wear much. Only normal scuffs and such. I have to note that in order to run the BCE you need the Hara Engine mount (As its 1mm taller) then the stock D8 one. Also you will need to add the D8 Truggy Center Diff shims / spacers.

Other then the above - it's a great chassis and I've had a few hard crashes / tumbles, and its bounced right back and never missed a beat.

Also the BCE is just about 1/2 inch longer over all then the stock D8 chassis.