morocho1979

Hello i have a trouble with my truggy hotbodies the rear driveshaft popout i change driveshaft ,rear arm,rear hub ,upperlinks,outdrive and still popout what can i do ???

NDHotbodies

iTrader: (2)

go to the D8t thread, this has been brought up a couple times and those guys well help you out.. all 3 of my D8ts do this also..

rceefreak

iTrader: (154)

Not sayin this what is goin on here, but do u have the rear hubs on the correct sides. I know with some if u have the right hub on the left side and vice versa it makes the width wider and dogbones don't sit as far in the outdrive as they should be. Just a thought

rageworks

iTrader: (47)

Try running less drop on the rear arms.

NDHotbodies

iTrader: (2)

my droop is currently set at pretty much straight across even with the chassis.. can not let it go any lower than that as the axle will pop out.

jbright33

iTrader: (15)

measure your axles, make shure chassis wasnt drilled wrong. droop should nut be a issue you can run 116 and the shouldnt pop out. something is either bent, flexing or just wrong.

NDHotbodies

iTrader: (2)

I just came from checking one of my trucks and on the right rear with no droop setting, the axle would probably pop out.. the left side is in a little farther.. I'll check the other two trucks the next couple nights..the one I checked probably has two races on it and no hard hits or wrecks were done on this one..everything else looked good and straight, bearings are good..as are the drive cups..