thomasgoalie2

hi im finding it hard Turning the wheels on the bend could it be because i have dirt in it or i do i need a new sevo or can u make them looser thanks

jwm2

iTrader: (5)

Check the servo saver, be sure its not binding or gripping on anything. I had a similar problem last week and found it was the adjustment screw rubbing on the chassis causing the resistance. I tightened it up some and all was good again.

merdith6

iTrader: (3)

Some servo horns rub on the top of the servo around where it bolts down, you may need to trim the servo horn around the bottom where the splines are...