R/C Tech Forums

Go Back   R/C Tech Forums > General Forums > Nitro Off-Road

Reply
 
Thread Tools Search this Thread
Old 07-24-2010, 07:31 PM   #1
Tech Rookie
 
Join Date: Jul 2010
Posts: 7
Default Even when you get the right part number............

it still may not work.

i got my parts as per my explosion diagram in my manual and purchased the one way bearing for my mach.26

installed and put the backplate on and noticed it didn't sit flush against the black as it did before. In addition, the motor wouldnt rotate. i looked the new bearing over, and compared to my old one and the new one is too tall for my motor.

here's a pic of them side my side (note: the new OWB is on the left)
Even when you get the right part number............-dsc01397_crop.jpg
and heres both again with the id card for the new part that doesn't fit.
Even when you get the right part number............-dsc01400_crop.jpg
looks like ill be sweet talking Losi come monday.
i hope im the only one having to deal with this problem instead of the possibility of bad bearings floating around.
BaldNitroJunkie is offline   Reply With Quote
Reply

Similar Threads
Thread Thread Starter Forum Replies Last Post
The Big Locked Thread donitaROSE Manila Racers 89718 03-26-2015 07:17 AM
SO I FLAMED MAXIMO YOU BE THE JUDGE. vladconnery Buyer/Seller dispute and Feedback discussion forum 56 02-07-2010 04:25 PM



Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are Off



All times are GMT -7. It is currently 04:36 PM.


Powered By: vBulletin v3.9.2.1
Privacy Policy | Terms of Use | Advertise Content © 2001-2011 RCTech.net