Lawson1024

Hi chaps. Upon installing my new engine;

http://www.apexmodels.com/media/gbu0...800-M20HSG.jpg

the LSN is at such an angle, that it is completely obscured by the exhaust. Surely this is going to make any kind of tuning extremely difficult to say the least?

PS. Also, there's no idle screw? Unless i'm going crazy

j_blaze14

iTrader: (34)

the lsn is on the right side where the boot is, the hsn is the gold one and the idle screw is the tough one to get to on the front of the carb.

Lawson1024

Is this correct? If so, though it's hard to see from the pic, the exhaust completely blocks the LSN

mrbusta

iTrader: (20)

that in the pic is ur idle mate
ur lsn is the opposite side were the boot is
and with ur idle screw location u may need to slide in from under the pipe