Losi 8T clutch bell question
#1
Tech Regular
Thread Starter
Losi 8T clutch bell question
Hi,
Could you tell me if Robinson clutch bell uses the same bearings as standard Losi 8T 1.0 clutch bell?
Sorry but I can't post URL's (not enough posts yet ).
Losi bearing sizes are:
1) 5x10x4mm
2) 5x13x4mm
And which would you recommend - both cost the same?
Thanks,
Donat
Could you tell me if Robinson clutch bell uses the same bearings as standard Losi 8T 1.0 clutch bell?
Sorry but I can't post URL's (not enough posts yet ).
Losi bearing sizes are:
1) 5x10x4mm
2) 5x13x4mm
And which would you recommend - both cost the same?
Thanks,
Donat
#2
Tech Lord
iTrader: (148)
The robinson racing clutch bells for the losi 8ight vehicles are the best. They work in the 1.0 and 2.0 and yes they take the stock size losi clutch bearing where the inner bearing is larger than the standard outter bearing. They weigh the same and hold up great. I have been using them for almost 2 yrs now.
#4
Tech Regular
Thread Starter
The robinson racing clutch bells for the losi 8ight vehicles are the best. They work in the 1.0 and 2.0 and yes they take the stock size losi clutch bearing where the inner bearing is larger than the standard outter bearing. They weigh the same and hold up great. I have been using them for almost 2 yrs now.
Ohh yea I almost forgot. I like os engines.
Ohh yea I almost forgot. I like os engines.
...sorry... I have JPX.
#6
yea i was wordering about there cluchbell also are they the best if u run all alum cluch setup and last a long time
#7
Tech Regular
Thread Starter
I've got one more question (it's not connected to this thread but it's too simple to start a new one).
I've bought a fuel filter (O'Donnell ODOC1790) but I don't know in which direction it should be mounted. The stainer should be closer to fuel tank or to engine (carbulator)?
It's a very simple thing but i can't explain it better... I hope you understand
Donat
I've bought a fuel filter (O'Donnell ODOC1790) but I don't know in which direction it should be mounted. The stainer should be closer to fuel tank or to engine (carbulator)?
It's a very simple thing but i can't explain it better... I hope you understand
Donat
#8
I've got one more question (it's not connected to this thread but it's too simple to start a new one).
I've bought a fuel filter (O'Donnell ODOC1790) but I don't know in which direction it should be mounted. The stainer should be closer to fuel tank or to engine (carbulator)?
It's a very simple thing but i can't explain it better... I hope you understand
Donat
I've bought a fuel filter (O'Donnell ODOC1790) but I don't know in which direction it should be mounted. The stainer should be closer to fuel tank or to engine (carbulator)?
It's a very simple thing but i can't explain it better... I hope you understand
Donat
you want the filter to be able to fill up with no restriction and filter out....so you would want the filter facing towards the carb.