tomkat

Greetings RC fellas,

I just received my RB S9 yesterday and to my surprise the carburetor slider is on the opposite side of what I am used to. I can't really figure whether I simply just turn the carburetor 180 degrees (meaning the side with the idle screw will be facing downwards torwards the flywheel) or whether I am suppose to (if even possible?) take the carburetor apart an move the slider on the other side? Anyone been faced with this challenge on this particular engine?

Thanks!

Friendly Regards,
/Tom

pickle311

iTrader: (31)

Loosen the pinch bolt and orient the carb however you need it.

rossoh10

iTrader: (10)

loosen the pinch bolt.Take the carb out and turn it around..Mount the enginein your car.make fine adjustment to the carb in the direction you need to go and then retighten the pinch bolt