Need help fast...racing tomorrow!
Hey guys...I need some quick advice. I am racing tomorrow morning. I just got a Spectrum Receiver and I was attempting to plug in my transponder when I noticed the plug does not fit. How can I remove the plug and add a different type of plug that fits? I can take one off an extra servo I have, but just not sure how to switch them. Please help asap!! Thanks!
|
Originally Posted by Ryno RC
(Post 6302878)
Hey guys...I need some quick advice. I am racing tomorrow morning. I just got a Spectrum Receiver and I was attempting to plug in my transponder when I noticed the plug does not fit. How can I remove the plug and add a different type of plug that fits? I can take one off an extra servo I have, but just not sure how to switch them. Please help asap!! Thanks!
mine was the same way.....if its a AMB trans take a hobby knife and shave the extra flange off the side |
More than likely, your plug has a small index tab on it (Futaba Style???). Take a sharp knife, and CAREFULLY cut it close to flush with the plug body. Once it is trimmed, take a file, and finish removing the tab. There is a small bevel on one of the corners of the connector, that indexes to the small angular tab on the receiver.
Hope this helps |
Just chop off the little extra peg theres nothing in side the peg. Its just for support
|
Sorry, my fault, I got it to fit! I had to push it in a certain direction before pushing down to get it to fit. At first I didn't want to use excessive force but after pushing it to the bottom side a bit it worked. Thanks guys for your very fast repies. I'd be lost without these forums!
|
All times are GMT -7. It is currently 01:39 PM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.