Jammin JPX 21 Plus ( new)
#196
Tech Adept
iTrader: (12)
Join Date: Nov 2009
Location: Tampa, Florida - from Clay Country
Posts: 218
Trader Rating: 12 (100%+)
Who sells these PICCO turbo plugs? AMain does not have them.
#197
#198
just recieved my dynamite 086 pipe today for my jammin. looks pretty sweet. cant wait to try it out next weekend. hopefully i can get better mileage with pipe too
#199
Tech Regular
iTrader: (19)
Post back your results with that set up. That is what I have and I am going to run 20 % fuel but I haven't broke the motor in yet .But I would like to know what run times you are getting and what setup you were using and what run time if you don't care to share. Thanks
#200
Post back your results with that set up. That is what I have and I am going to run 20 % fuel but I haven't broke the motor in yet .But I would like to know what run times you are getting and what setup you were using and what run time if you don't care to share. Thanks
#201
that will use more fuel.....better to have a lower engaement, plus a JPX 21 feels horrible on 1.1's as it has so much torque
As I say, make sure you run Picco plugs..I cannot stress this enough..
#202
oh ok im going back to 1.0 springs then. and yea im actually still on the same picco plug i broke it in on 3 gallons later.
#203
what would .9 springs be like in it with runtime and all?
#204
they are IMO the best glowplugs money can buy, they burn awesome and last forever...in a Picco it allows you to properly lean the engine down and not get detonation..OS plugs are all wrong for this engine and OD are not far off....
#205
what would .9 springs be like in it with runtime and all?
#206
.9 would soften the bottom and may give a slight bog on higher traction.... On a mod engine I run .9, but the mod engine has a ton of torque to work with...on a stock JPX .21 I would run .95 if i could get them....... Also consider going up 1 tooth on the clutchbell, sometimes that helps keep the tire spin down, and increase fuel mileage....
#207
awesome thanks for all info man!
#208
#209
Tech Adept
iTrader: (12)
Join Date: Nov 2009
Location: Tampa, Florida - from Clay Country
Posts: 218
Trader Rating: 12 (100%+)
Neal, I just a JP3 pipe. Not sure what good it will be with this mill. But I just have to try it. I also have the Ofna 086. Mill has just about 1.5 gals on it.
Thanks for the advice given here, loads of info.
Thanks for the advice given here, loads of info.
#210
ive seen many people run the jp3 and they have had great success with it