R/C Tech Forums

Go Back   R/C Tech Forums > General Forums > Nitro Off-Road

Reply
 
Thread Tools Search this Thread
Old 08-16-2009, 11:32 AM   #1
Tech Rookie
 
LipoXrayEvo2's Avatar
 
Join Date: Apr 2009
Location: San Diego
Posts: 9
Wink MGT Monster GT Drivetrain

Hi, I have a MGT with the XTM 457 motor (which is prob why this is happening)
Anyway, I keep snapping my rear drive-shaft CVD pin right on the transmission output cup.
If I loosen up my slipper it "slips" and melts my spur gear.(should I invest in the steel one?)
If I tighten it back up it snaps the pin.

So basically my question is, is there an upgrade for this that I haven't found?
And, how tight should I make my slipper?

Thanks everyone.
__________________
When in doubt...... Just gas it !!
Lipo baby Lipo
RC10GT, MGT, Wheely King Crawler, TC3, XrayT1Evo2, and some stupid Helicopter I can't fly to save my life.
LipoXrayEvo2 is offline   Reply With Quote
Reply



Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are Off



All times are GMT -7. It is currently 10:13 AM.


Powered By: vBulletin v3.9.2.1
Privacy Policy | Terms of Use | Advertise Content © 2001-2011 RCTech.net