R/C Tech Forums

Go Back   R/C Tech Forums > General Forums > Nitro Off-Road

Reply
 
Thread Tools Search this Thread
Old 07-18-2009, 09:35 PM   #1
Tech Master
 
Garet Jax's Avatar
 
Join Date: Jun 2009
Location: Baltimore, MD
Posts: 1,332
Trader Rating: 91 (100%+)
Default What is this.....

The description from amain (where I got the picture says):

(1) Base Mount
(1) Set of top blocks
(8) 5-40 x 1/2" Alloy Allen Head Cap Screws
(4) M3 lock washers (used with screws that hold the top blocks to base)

It mentions nothing of the piece I circled. Thanks.
Attached Thumbnails
What is this.....-king-headz-extended-motor-mount.png  
__________________
I am not a "Tech Master" nor even close. I simply have a lot of posts. If you want some sage advice, the only that I can give is don't listen to me.
Garet Jax is offline   Reply With Quote
Old 07-18-2009, 09:46 PM   #2
Tech Elite
 
rallyebmx's Avatar
 
Join Date: May 2007
Posts: 2,863
Trader Rating: 21 (100%+)
Default

I have that mount. I did not have that piece.
rallyebmx is offline   Reply With Quote
Old 07-18-2009, 09:49 PM   #3
Tech Initiate
 
crotty777's Avatar
 
Join Date: Jun 2009
Location: P-town, NV
Posts: 40
Trader Rating: 1 (100%+)
Default

it replaces yor plastic fuel tank mount. it goes at the end of the extended side of the lower plate
__________________
*Dialed RC Hobbies, Windwater RC, Kustom Kolors, HRP, Sweep Racing,
RC Concept*
crotty777 is offline   Reply With Quote
Old 07-18-2009, 09:51 PM   #4
Tech Initiate
 
crotty777's Avatar
 
Join Date: Jun 2009
Location: P-town, NV
Posts: 40
Trader Rating: 1 (100%+)
Default

Quote:
Originally Posted by rallyebmx View Post
I have that mount. I did not have that piece.
that engine mount is for a losi. they dont all have the tank mount
__________________
*Dialed RC Hobbies, Windwater RC, Kustom Kolors, HRP, Sweep Racing,
RC Concept*
crotty777 is offline   Reply With Quote
Old 08-08-2009, 10:20 AM   #5
Tech Master
 
Garet Jax's Avatar
 
Join Date: Jun 2009
Location: Baltimore, MD
Posts: 1,332
Trader Rating: 91 (100%+)
Default

Quote:
Originally Posted by crotty777 View Post
it replaces yor plastic fuel tank mount. it goes at the end of the extended side of the lower plate
Well I finally went to install the mount and now I know what you mean. I bought the mount used and the piece did not come with it. Do you happen to know the part # and/or where or not I can buy it used?

Thanks.
__________________
I am not a "Tech Master" nor even close. I simply have a lot of posts. If you want some sage advice, the only that I can give is don't listen to me.
Garet Jax is offline   Reply With Quote
Old 08-08-2009, 02:21 PM   #6
Tech Lord
 
Integra's Avatar
 
Join Date: Dec 2006
Posts: 12,482
Trader Rating: 8 (100%+)
Send a message via MSN to Integra
Default

Quote:
Originally Posted by Garet Jax View Post
Well I finally went to install the mount and now I know what you mean. I bought the mount used and the piece did not come with it. Do you happen to know the part # and/or where or not I can buy it used?

Thanks.


Call up Jim at Kingheads and he will take care of you....I Think they might have it listed as a single item on their site but not too sure.



Quote:
Originally Posted by rallyebmx View Post
I have that mount. I did not have that piece.

then your tank would not be supported on 1 end...or you cut or modified the stock post to make it work...its not possible to run That particular mount without that piece....you must have bought the non extended version.
__________________
TNS Driver - Radio Post - Blue Groove Apparel - Team Panther - Hitec - Losi - W.E.D. Paint - Clockwork Fuel - Competition Heat - SUMO Racing - Tekin - Team Terribles - M2C Racing - Matrix Concepts - Kal Gard - BuKu Power - DE Racing -
Integra is offline   Reply With Quote
Reply

Similar Threads
Thread Thread Starter Forum Replies Last Post
Gamers..What are you playing right now?? speedemall Chat Lounge 1082 10-23-2011 08:38 PM
If piston gets stuck at TDC, is it a sign that it's not broken in? PrimeAKF11 Nitro On-Road 13 08-18-2009 09:30 PM
What is the Coolest Trick You Did With RC TRXRustler33 Chat Lounge 36 08-16-2009 03:19 PM
What's your input on 1/10 Electric Touring Min weight? SweepRacingUSA Electric On-Road 70 08-16-2009 09:18 AM
Does this look ok ? Need some thoughts pls Omarko Onroad Nitro Engine Zone 30 08-12-2009 04:28 PM
motohead24 is a no good ! jldjlaudio Buyer/Seller dispute and Feedback discussion forum 26 08-11-2009 10:58 AM



Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are Off



All times are GMT -7. It is currently 04:39 AM.


Powered By: vBulletin v3.9.2.1
Privacy Policy | Terms of Use | Advertise Content © 2001-2011 RCTech.net