Quick Question
06-12-2009, 11:23 AM
#1
Quick Question
Will this setup work on a traxxas 3.3 motor? If not what is a better setup? And last, are clutches a one size fits all deal or are their specific clutches made for specific motors/vehicles? I am new to nitro so any help would be appreciated!
http://answer-rcusa.com/zencart/inde...products_id=91
http://answer-rcusa.com/zencart/inde...products_id=91
06-12-2009, 12:50 PM
#2
i would suggest going to the traxxas web site and getting a setup sheets
06-13-2009, 01:58 PM
#5
Was told the best setup for the 3.3 was the MIP clutch.....
http://www3.towerhobbies.com/cgi-bin...&I=LXNTU1&P=ML
What you linked may work and apparently has the pieces to get it spaced out correctly, but I'd worry about the supplied collet. Not had much luck with universal type collets. At least you know it will fit the flywheel which is half of it.
http://www3.towerhobbies.com/cgi-bin...&I=LXNTU1&P=ML
What you linked may work and apparently has the pieces to get it spaced out correctly, but I'd worry about the supplied collet. Not had much luck with universal type collets. At least you know it will fit the flywheel which is half of it.
06-14-2009, 04:18 PM
#6
Was told the best setup for the 3.3 was the MIP clutch.....
http://www3.towerhobbies.com/cgi-bin...&I=LXNTU1&P=ML
What you linked may work and apparently has the pieces to get it spaced out correctly, but I'd worry about the supplied collet. Not had much luck with universal type collets. At least you know it will fit the flywheel which is half of it.
http://www3.towerhobbies.com/cgi-bin...&I=LXNTU1&P=ML
What you linked may work and apparently has the pieces to get it spaced out correctly, but I'd worry about the supplied collet. Not had much luck with universal type collets. At least you know it will fit the flywheel which is half of it.
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
