GRP Engine Tool
Anyone have any experience with the GRP engine tool for tearing down an engine good or bad. I know the good old heat method works, but when there are special tools that do the job, why not use them? I am about to use this tool to break down an engine and replace the bearings. Any comments or special tips?
|
I'd like to find out if GRP's engine tool will only work with GRP bearing sizes? It would be nice if that $170 could be used on other engine bearing sizes.
|
i have used my GRP engine tool to tear down vspecs, nova's, grps, and mugen motors. Works like charm.
|
Originally Posted by Bigedmond
(Post 5741192)
i have used my GRP engine tool to tear down vspecs, nova's, grps, and mugen motors. Works like charm.
|
You dont need to. But i do, just to make sure.
|
I suppose you can heat it, would not hurt at all. But, you don't have to and it will smoothly pull them and put them in!
It's a very nice tool. |
Originally Posted by ABURTON
(Post 5742476)
I suppose you can heat it, would not hurt at all. But, you don't have to and it will smoothly pull them and put them in!
It's a very nice tool. |
All times are GMT -7. It is currently 04:38 AM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.