Its 53degress out and my rustler is running lean on break in???
#1
Its 53degress out and my rustler is running lean on break in???
Ive countlessly been trying to break this rustler in without problems. But they come one after another. When I finally got it running and tried to break the car in I started to notice smoke stopped coming out the pipe and the idle would gradually rise. Eventually the tires started to spin real fast when I pick it up (on idle). The idle screw is set as low as it can go. I didnt touch the needles for break in?? MY spit evaporated in a few seconds. Whats going on?
Note: Outside temp- 53 degrees
Note: Outside temp- 53 degrees
Last edited by RaV3N; 02-12-2009 at 06:54 AM.
#2
Tech Adept
It sound like your low speed may be a little lean try to richen it up a bit and if that does not work look for air leaks.
#3
Ok will do.
#6
Now when I go to give it gas it dies? to rich?
#7
Tech Adept
Hard to tell, how much did you change. The LSN is very sensitive, and hour or 2 is about the max you should adjust at once. Also as someone mentioned check your idle gap, it should be as wide as a paper clip.
#8
Yea I set the idle gap. But even on richer high and lowe speed needles I still dont get any exhaust smoke.