Rebound Adjustment Screw (MBX5) WTF?
#1
Rebound Adjustment Screw (MBX5) WTF?
There is a set screw in the lower arms on the MBX5. It just screws into the arm itself, no other component comes in contact with it.
WTF is that about? The manual (I use that term loosely) doesn't say squat about it, of course.
WTF is that about? The manual (I use that term loosely) doesn't say squat about it, of course.
#2
Tech Adept
if its beside or near the inner hinge pin than it sounds like a droop screw
#4
it s a droop screw. to limit droop of course it needs to go through the arm and touch chassis. thats standard on all racing truggies/buggies
#5
i dont see any reason you couldn't do this to another brand chassy.
#6
Tech Adept
#7
Droop does alot more than that. Too start you should set the car so the wheels are off the ground and screw in the droop screw until it JUST starts to move the arm. This will give you maximum droop as well as keep you from breaking shocks.
#8
Tech Adept
#9
I said it was a starting point. Most people dont take too much droop out. But yeah too much can be bad too. I would rather have too much than not enough. hhmmmm D8