some trinity extech .24 questions???
#1
some trinity extech .24 questions???
hello everyone. so as the title reads im planning on putting a trinity .24 in my hyper st. ive been told it shoud fit no problem. but when i started thinking about the right clutch to use. i was perplexed. you think i should just use the macstar .28 clutch? that doesnt sound right, putting a cheap engines clutch system on a mill like the trinity extech .24. so anyone know what i should be looking for when buying a new clutch system for when i put the trinity .24 in my hyper? thanx a lot, clay unruh
#2
The X-Tech will work with any clutch that works to your satisfaction,
looks like about any 3 shoe setup will work, here is the stock OFNA setup
http://www.rcplanet.com/Clutch_System_s/692.htm
i think i would rephrase the question to ask what cluch works best on this truck........
more than likely the clutch that came on your truck is OFNA not macstar...
...just make shure the shoes are in good shape bearings are in good shape and you should be fine......
looks like about any 3 shoe setup will work, here is the stock OFNA setup
http://www.rcplanet.com/Clutch_System_s/692.htm
i think i would rephrase the question to ask what cluch works best on this truck........
more than likely the clutch that came on your truck is OFNA not macstar...
...just make shure the shoes are in good shape bearings are in good shape and you should be fine......
Last edited by BAUSTIN; 02-06-2009 at 05:13 AM.
#3