OFNA ULTRA MBX PRO
03-09-2009, 04:11 PM
#1
OFNA ULTRA MBX PRO
hey everyone, i got a few questions about my buggy, first off it has a axial 28RR motor in it and i am thinking about changing out the clutch bell and the spurr gear and was wandering what tooth setting would be good for it? and also i was thinking about putting in a 2speed transmission and was wandering if ne one knows how easy it can be done or what not?
Thanx,
Daniel
Thanx,
Daniel
03-10-2009, 08:46 AM
#3
Tech Adept
The more teeth on the clutch bell gear more top speed (less acceleration)
The less teeth on the clutch bell gear more acceleration. (less top speed)
A 2spd. can give you both. I would use a 2spd. for bashing.
Hope This Helps.
The less teeth on the clutch bell gear more acceleration. (less top speed)
A 2spd. can give you both. I would use a 2spd. for bashing.
Hope This Helps.
03-10-2009, 12:38 PM
#4
my gears
well i just looked up my buggy parts and it has a 51 tooth spur gear and A 14 tooth clutch bell, i found out if i were to do a two speed tranny i have to mod my chassis by cutting a bigger hole where the spur gears sit. so yea not to sure
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
